DIY Heating Furnace Repair Tips
• Set your thermostat as low as is comfortable.
• Clean or replace filters on furnaces once a month or as needed.
• Clean warm-air registers, baseboard heaters, and radiators as needed; make sure they're not blocked by furniture, carpeting, or drapes. • Use kitchen, bath, and other ventilating fans wisely; in just 1 hour, these fans can pull out a houseful of warmed or cooled air. Turn fans off as soon as they have done the job.
• Keep draperies and shades open on south-facing windows during the heating season to allow sunlight to enter your home; close them at night to reduce the chill you may feel from cold windows.
• Close an unoccupied room that is isolated from the rest of the house, such as in a corner, and turn down the thermostat or turn off the heating for that room or zone. However, do not turn the heating off if it adversely affects the rest of your system. For example, if you heat your house with a heat pump, do not close the vents—closing the vents could harm the heat pump.
• Select energy-efficient equipment when you buy new heating equipment. Your contractor should be able to give you energy fact sheets for different types, models, and designs to help you compare energy usage.
Heat Pump Tips
• Do not set back the heat pump's thermostat manually if it causes the electric resistance heating to come on. This type of heating, which is often used as a backup to the heat pump, is more expensive.
• Clean or change filters once a month or as needed, and maintain the system according to manufacturer's instructions.
• If you never use your fireplace, plug and seal the chimney flue.
• Keep your fireplace damper closed unless a fire is going. Keeping the damper open is like keeping a 48-inch window wide open during the winter; it allows warm air to go right up the chimney.
• When you use the fireplace, reduce heat loss by opening dampers in the bottom of the firebox (if provided) or open the nearest window slightly— approximately 1 inch—and close doors leading into the room. Lower the thermostat setting to between 50º and 55ºF.
• Install tempered glass doors and a heat-air exchange system that blows warmed air back into the room.
• Check the seal on the flue damper and make it as snug as possible.
• Add caulking around the fireplace hearth.
• Use grates made of C-shaped metal tubes to draw cool room air into the fireplace and circulate warm air back into the room.
NEED A REPAIR PART FAST? CLICK HERE!
........troubleshooting.............AND MUCH MORE!